technical data sheet 1/3 right angle plug clamp type r114.165.000 cable 2.6/50+75 s series : smb issue : 0050 q in the effort to improve our products, we reserve the right to make changes judged to be necessary. all dimensions are in mm. .. pn ao components body center contact outer contact insulator gasket others parts - - materials brass beryllium copper beryllium copper ptfe - brass - - platings ( m) gold 0.2 over nickel 2 gold 1.3 over nickel 2 gold 0.5 over nickel 2 gold 0.2 over nickel 2 - -
technical data sheet 2/3 right angle plug clamp type r114.165.000 cable 2.6/50+75 s series : smb issue : 0050 q in the effort to improve our products, we reserve the right to make changes judged to be necessary. packaging standard unit o ther 100 ?w? option contact us electrical characteristics impedance 50 ? frequency 0-4 ghz vswr 1.35 + 0.040 x f(ghz) maxi insertion loss 0.50 f(ghz) db maxi rf leakage - ( 57 - f(ghz)) db mini voltage rating 335 veff maxi dielectric withstanding voltage 1000 veff mini insulation resistance 1000 m ? mini mechanical characteristics center contact retention axial force ? mating end 10 nmini axial force ? opposite end 10 nmini torque na n.cm mini recommended torque mating na n.cm panel nut na n.cm clamp nut 40 n.cm a/f clamp nut 5.000 mm mating life 500 cycles mini weight 4.800 g environmental operating temperature -65/+165 c hermetic seal na atm.cm3/s panel leakage na specification cable assembly stripping abcdef m m 1.50 0.00 4.00 5.00 2.00 0.00 assembly instruction : recommended cable(s) kx 22a rg 179 rg 188 rg 187 rg 316 cable retention - pull off 110 nmini - torque na n.cm tooling part number description hexagon .. . others characteristics -
technical data sheet 3/3 right angle plug clamp type r114.165.000 cable 2.6/50+75 s series : smb issue : 0050 q in the effort to improve our products, we reserve the right to make changes judged to be necessary. components 1 3 2 4 mount the braid-clamp trim braid to? of braid-clamp stripp off the dielectric body washer 1 gasket clamp nut washer 2 braid-clamp cap screw sub-assembly into the connector body with the adapted wrench. recommended coupling torque (see connector tds). solder the inner conductor. place the cap into the body. press on the cap flush or slightly below the surface of the body assembly. slide the back nut,the washer1 ,the gasket,the washer2 onto the cable. strip the cable. cut 2 slits in the jacket if necessary. 2 slits at 180
|
